Know How To Use a China Saddle Clamp Making Tool

  •  

    The one-of-a-kind China saddle clamp Making Tool allows you to make strong, reliable clamps out of simple Stainless Steel Safety Wire. It can be used to replace worn or ineffective hose clamps, or to create clamps on virtually any material by tightening wires around an object and locking them in place. Follow these instructions to create your own clamps today!clamptite-beauty.jpg

    Single Wrap Application

    Step 1
    Insert end of wire into front pin on the left side of the tool
    Bring wire over the nose and in front of the front pin on the right side of the tool
    Wrap wire around hose or object to clamp (as many wraps as desired)
    Bring wire over the top of the wraps and around the rear pin on the right hand side
    Take wire over the top of the tool and around the pin on the left hand side

    Step 1 (Alternative)
    Place loop of wire around nose and twist to tighten
    Wrap wire around hose or object to clamp (as many wraps as desired)
    Bring wire over the top of the wraps and around the rear pin on the right hand side
    Take wire over the top of the tool and around the pin on the left hand side

    Step 2 Turn wing nut to tighten
    When clamp has reached desired tension, rotate tool 180° to lock clamp
    Loosen wing nut and remove clamp making tool
    Clip wire ends about ¼ inch from clam and push down toward hose or object clamped


    Double Wrap Application

    Step 1
    Cut wire to length (4 times around project plus 12” for tool)
    Fold wire in half, tape or wire nut ends together
    Wrap around hose where you want a clamp
    Tuck ends through the loop

    Step 2
    Continue to wrap around in the same direction; tuck through loop again and remove tape or wire nut
    Place tool as shown with wire over front pin and around rear pin
    Twist ends together tightly about 6 twists as close to the body of the tool as possible

    Step 3
    Place notch at end of tool against the wire loop
    Turn wing nut clockwise to tighten (right hand threads)

    Step 4
    Rotate tool over to lock the clamp, bending wires back over themselves
    Loosen wing nut and remove the tool
    Clip off wire ends about ¼ inch from clamp and push ends down against the hose.

    Welcome to contact us if you are interested in pp compression fitting!