Principle Analysis Of Chlorodifluoromethane R-22

  • Principle analysis: Chlorodifluoromethane R-22, that is, CHCLF2 is a pure substance with a purity of at least 99%; the counterfeit R22 on the market currently contains monochloromethane and other corrosive substances with a high proportion. Monochloromethane is highly corrosive and will cause severe corrosion to the compressor of the refrigeration unit, resulting in the scrapping of the compressor.


    Reminder: There are many counterfeit methods that are hard to guard against. Don't be greedy for cheap purchases. You must buy well-known big brands, such as Juhua, Chemours, Honeywell, etc...

    For other refrigerants, we can use the following methods to make a simple judgment:

    Method 1: Turn the refrigerant tank upside down and release a small amount of refrigerant onto a piece of white paper. If there are obvious impurities or liquid water on the white paper, it means that the refrigerant is of poor quality and is not recommended;

    Method 2: Connect the pressure gauge to test the pressure of the refrigerant bottle, and check whether the pressure in the bottle is within the normal range by comparing it with the refrigerant temperature and pressure characteristic table. If the pressure is obviously abnormal, it is not recommended.

    Method 3: When the refrigerant is half used, the pressure in the bottle can be tested again. For a single-component refrigerant such as R22, the two measured bottle pressure values ​​should be very close, but for inferior refrigerants, multiple components are usually mixed , After using the refrigerant in the bottle, the pressure of the bottle usually varies greatly due to the change of the composition ratio. If such a phenomenon is encountered, it is recommended to stop the refrigerant immediately and discharge the refrigerant that has been charged into the system. To avoid polluting the system.

    Method 4: During the system debugging and operation stage, if the following abnormal phenomena are found

    1) When the system's refrigeration capacity is obviously insufficient and no other abnormalities are found after inspection, you need to pay attention to the refrigerant; 2) When the system dryer filter or expansion valve is blocked, and the blockage is yellow-brown wax-like or black sludge-like foreign matter Need to pay attention to refrigerant;

    3). High and low pressure or temperature abnormalities occur during system operation, or the system balance pressure is abnormal when the system is stopped (refer to the refrigerant temperature and pressure characteristics table), and the refrigerant needs to be paid attention to.

    When these abnormal phenomena occur, it is recommended to extract refrigerant from the system for purity testing to troubleshoot the risk of inferior refrigerant.

    In the meantime, it is recommended to empty the refrigerant on the compressor side or release the refrigerant in the whole system to avoid the potentially inferior Fluorinated Solvent from contacting the compressor and damaging the compressor.